![]() special emulsifiers, water, and other additive have been gone through anionic Slow Setting bitumen Emulsion is the cold/non-fibered liquid applied waterproofing bitumen emulsion.Īnionic SS-1h must be spray applied by using a suitably calibrated distributor & experienced personnel.Emulsion SS-1h can be applied under the same conditions of the subsequent pavement placement however, break time and bond strength can be affected by extreme weather conditions. Anionic bitumen emulsion SS-1h is a slow setting, anionic type of bitumen. In an anionic emulsion, the droplets migrate from the anode. Anionic emulsion is obtained by an electric field. ![]() The main applications of Anionic bitumen emulsion are waterproofing, building application, highway construction, surfacing, and maintenance. By adding emulsifier into water and bitumen that is the alkaline salt with Ammonium Salt in the high-speed mixer at ISO condition making Bitumen SS-1h. In normal conditions and without emulsifier the two parts of emulsion SS1 is unstable and quickly will segregate. The particle size of the emulsion is 0.1 to 5 micron. Usage of anionic bitumen emulsion SS-1h is two phases of water and bitumen which are not possible to mix and the first interphase is inside of outer phase. Because of this, anionic emulsions are susceptible to temperature and humidity in terms of their breaking properties. With anionic emulsions, the breaking process is predominantly by evaporation of the water in the emulsion continuous phase. Therefore, stone mixtures require medium-setting Emulsions and sand mixtures require a slow-breaking emulsion. Rapid-setting emulsions are used for surface dressing, while medium or slow-setting emulsions are used for ‘mixtures’, that are mixed with aggregate either in concrete-type mixers or in situ. whether it is a cationic or an anionic emulsion) and how quickly the suspended asphalt particles separate from the surrounding water (“breaking”).įor anionic and emulsions, there are several grades of different braking characteristics. Asphalt emulsions are classified according to the electric charge that surrounds the emulsion’s asphalt particles (i.e. Shipping Method: Freight Shipping required, Business address and offloading ability- requires dock or an extra liftgate charge will apply.Description of Bitumen Emulsion Anionic SS-1hīitumen Emulsion Anionic SS-1h is a slow-setting anionic asphalt emulsion (i.e., low reactivity) low viscosity and a hard asphalt residue that is designed for various paving and industrial uses. The tote of Primer Tack Cote does have cage surround. ![]() Tote Size: 275 Gallons filled to APPROXIMATELY 250 gallons (250 gallons included). Do not use if rain is imminent, when surface is wet or when temperature is below 50☏.ĬOVERAGE PER GALLON: 500 Square Feet Per Gallon Stay Mat will set up under good conditions within 30 minutes depending on weather and material coating thickness. Stay Mat Tack Coat can be applied with common sprayer, broom, mop or squeegee. SURFACE PREPARATION: Surface must be clean, dry and free of all dirt dust and debris.ĪPPLICATION: Mix well before use.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |